cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can change your system assigned username to something more personal in your community settings. X

MultiAxis Milling w Creo NC Tips & Techniques Session Recording (West Coast)

No ratings

Check out this video on MultiAxis Milling w Creo NC from PTC Application Engineers

Presenters: Lee Goodwin (Solution Consultant, Principal) and Ryan Butcher (Solution Consultant, Fellow)

Original Date Presented: October 17, 2023


To dive deeper into the subject, check out MultiAxis Milling.

 

Comments

WEBCAST Q&A

 

Question from Alex:  Does changing the retract surface to a curved surface reduce the accuracy of the machining?

Answer:  No, basically it should only effect the start and stop in your toolpath.  It controls the amount of pull out only.  It will only effect the entry and exit.

WEBCAST Q&A

 

Question from Dennis:  Can you split the toolpath so the next tool starts where the first one ended?

Answer:  It won't remember the last position of the tool in the 1st toolpath to start there on the 2nd toolpath.  Something that works well for this is using "at a location" for axis control.

WEBCAST Q&A

 

Question from Wayne:  Is there a collision detection option so we don't have to check only by eyeballing it?

Answer:  Yes, you can turn on and off collision detection.  The main thing that eyeballing does is it helps with deciding how to fix a problem with the toolpath.

Version history
Last update:
‎Dec 04, 2023 02:28 PM
Updated by:
Labels (3)
Contributors