Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email.
X
What's New in Creo 10 Tips n' Techniques (West Coast)
No ratings
Check out this video on What's New in Creo 10 Tips and Techniques session from PTC Application Engineers. Presenters: Jason Petersen (Solution Consulting, Principle) and Ryan Butcher(Solution Consulting, Fellow).
Question from Kevin: We have seen that when we split surfaces, both surfaces appear to get a new ID. This results in child feature and assembly failures. Is/has this been addressed?
Answer: Yes, this would change the IDs as the underlying geometry is different. There are ways of addressing this but that is dependent on the use case.
