cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

Phantom Display from Creo Illustrate to Thingworx Studio

tdevasagayam
5-Regular Member

Phantom Display from Creo Illustrate to Thingworx Studio

Hi,

Is there any way to make solids/surfaces as Phantom (Creo Illustrate - Object Display Style) in Thingworx Studio?

Though I make a solid phantom in Creo Illustrate, after importing into Thingworx Studio could not see that.

Regards,

Thadeus.D

1 ACCEPTED SOLUTION

Accepted Solutions

Hi Thadeus, There does not seem to be a Phantom option withing Studio. You can use a Model Item to isolate the part and then change the opacity/transparency of the part.

View solution in original post

1 REPLY 1

Hi Thadeus, There does not seem to be a Phantom option withing Studio. You can use a Model Item to isolate the part and then change the opacity/transparency of the part.

Top Tags